Canon CLC5151 Copying And Mail Box Manual page 83

NOTE
To recall a paper size from a size key ([S1] to [S5]), it is necessary to register a paper size in that
key beforehand. For instructions on registering a paper size, see Chapter 4, "Customizing
Settings," in the Reference Guide.
Press [Next].
Select the desired paper type
If you are printing onto the back side of a previously printed sheet, press [2nd Side of
2-Sided Page].
IMPORTANT
If you select a nonstandard paper size, the Rotate Collate, Rotate Group, Offset Collate, Offset
Group, Staple, 2-Sided Printing, Booklet, Cover/Sheet Insertion, Cover/Job Separator or Tab
Paper Creation mode cannot be specified.
To print on envelope loaded in the stack bypass:
Press [Stack Bypass].
If you want to select the stack bypass when a paper size/type is already selected for current
or reserved job, press [Stack Bypass Settings] to specify the desired paper size/type.
Press [Envelope].
Select the desired envelope type
IMPORTANT
• If the envelope type is not set correctly, a paper jam will occur.
• Do not use envelopes that have glue attached to their flaps, as the glue may melt due to the heat
and pressure of the fixing unit.
• If you select [Envelope], the Finishing, 2-Sided Printing, Cover/Sheet Insertion, Cover/Job
Separator, Booklet, Form Composition, or Tab Paper Creation mode cannot be specified.
Press [OK].
3
Press [Done].
4
Press [Start Print].
press [OK].
press [OK].
2-29
Paper Selection
2