Canon CLC5151 Copying And Mail Box Manual page 242

4
4-64
Using Image Creation Modes
Using the edit pen:
Press [Pen Entry].
Press [Start Scan].
IMPORTANT
Check that the original is placed on the platen glass.
Designate the area using the edit pen.
Mark the two opposing points with the edit pen.
NOTE
• To clear the first point entered, press [Erase Point]. (Once an area is designated, [Erase Point]
changes to [Clear Area].)
• To clear a designated area, press [Clear Area].
• To zoom in on any area on the original, press the ratio drop-down list
ratio press [ ], [ ], [
• To check the designated area, press [Preview].
• To modify a designated area that was specified by using the edit pen, press [Area Fine Adj.]
[Point select] select the point that you want to modify
move the point press [Done]
Press [OK].
Using the numeric keys:
Press [Numeric Key Entry].
IMPORTANT
• Before performing the next step, you must manually measure the size and position of the area
that you want to designate on the original.
• When you measure the XY values, always start measuring from the image out to the right side
edge of the original, and up to the top of the original. These measurements tell the machine the
desired framed area's size and position.
Press [X1], [X2], [Y1], and [Y2]
measurements press [OK].
[X1]: The distance of the area's right border to the original's right edge.
[X2]: The distance of the area's left border to the original's right edge.
[Y1]: The distance of the area's top border to the original's top edge.
[Y2]: The distance of the area's bottom border to the original's top edge.
], or [ ] to specify the area to display.
[Preview] to check the modified area.
use - (numeric keys) to specify the respective
select an enlargement
press [ ], [ ], [ ], or [ ] to