Canon CLC5151 Copying And Mail Box Manual page 36

1
2
1-16
Paper Selection
NOTE
To recall a paper size from a size key ([S1] to [S5]), it is necessary to register a paper size in that
key beforehand. For instructions on registering a paper size, see Chapter 4, "Customizing
Settings," in the Reference Guide.
Press [Next].
Select the desired paper type
If you are copying onto the back side of a previously printed sheet, press [2nd Side of
2-Sided Page].
IMPORTANT
If you select a nonstandard size paper, the Poster, Rotate Collate, Rotate Group, Offset Collate,
Offset Group, Staple, Book
Combination, Booklet, Tab Paper Creation, Job Block Combination, or Store In User Inbox mode
cannot be specified.
If you want to select the 1
the paper size after setting the 1
paper sizes can be used with the 1
- Width (X axis): 182 mm to 457 mm
- Length (Y axis): 105 mm to 305 mm
To copy on envelope loaded in the stack bypass:
Press [Stack Bypass].
If you want to select the stack bypass when a paper size/type is already selected for current
or reserved job, press [Stack Bypass Settings] to specify the desired paper size/type.
Press [Envelope].
Select the desired envelope type
IMPORTANT
• If you select [Envelope], the Poster, Finishing, 1
2-Page Separation, Cover/Sheet Insertion, Booklet, Transparency Interleaving, Image
Combination, Form Composition, Tab Paper Creation, or Job Block Combination mode cannot
be specified.
• If the envelope type is not set correctly, a paper jam will occur.
• Do not use envelopes that have glue attached to their flaps, as the glue may melt due to the heat
and pressure of the fixing unit.
Press [OK].
Press [Done].
press [OK].
2-Sided, 2-Page Separation, Cover/Sheet Insertion, Image
2-Sided or 2 2-Sided mode and nonstandard size paper, select
2-Sided or 2 2-Sided mode. The following nonstandard
2-Sided and 2 2-Sided modes:
press [OK].
2-Sided, 2 2-Sided, Book 2-Sided,