5
6
4
7
8
4-70
Using Image Creation Modes
Select [Framing] or [Blanking].
Details of each item are shown below.
[Framing]:
Copy only the contents of the designated area while discarding the rest of the
original.
[Blanking]:
Copy the original by blanking out the contents of the designated area.
If you want to use different settings for different areas, select the area by pressing the
appropriate area key
select [Framing] or [Blanking].
Press [Preview]
check the designated area
NOTE
• If the designated area is rectangular, and you want to continue designating other areas, repeat
steps 3 to 5. Areas that have already been designated are displayed with the new area.
• To modify a designated area that was specified using the edit pen, press [Area Fine Adj.]
[Point select] until the screen displays the desired point that you want to modify
[
], or [
], or [
] to move the point
area.
Press [Next]
select [Shift center] or [Do not shift center].
If only [Blanking] is selected, this step is unnecessary. Skip to step 8.
NOTE
• If the Center Shift mode is already specified beforehand, the Center Shift Settings screen does
not appear.
• The Center Shift settings specified within the Area Designation mode are deleted when the area
settings are cancelled.
Press [OK].
If you need to designate the same area for multiple originals, remove the original from the
platen glass
place all of the originals in the feeder
press [Done].
press [Done]
[Preview] to check the modified
press
.
press [
],