L2 Features > Voice Vlan > Voice Vlan Global; L2 Features > Voice Vlan > Voice Vlan Port - D-Link DMS-1100-10TS User Manual

Figure 4.67 – L2 Features > Auto Surveillance VLAN > MAC Settings and Surveillance Device
L2 Features > Voice VLAN > Voice VLAN Global
The Voice VLAN is a VLAN used to carry voice traffic from an IP phone. As the sound quality of Voice over
IP, is sensitive to delay Quality of service (QoS) for voice traffic should be configured to ensure that voice
traffic is handled with a higher priority.
The switches determine whether a received packet is a voice packet by checking its source MAC address. If
the source MAC addresses of a packet complies with the organizationally unique identifier (OUI) addresses
configured by the system, the packets are determined as voice packets and transmitted in voice VLAN.
The fields that can be configured for Voice VLAN Global Settings are described below:
Item
Voice VLAN State
VLAN ID (1-4094)
Voice VLAN CoS
Aging Time
Click the Apply button to accept the changes made.
L2 Features > Voice VLAN > Voice VLAN Port
The Voice VLAN Port page is used to show the ports voice VLAN information.
Figure 4.68 – L2 Features > Voice VLAN > Voice VLAN Global Settings
Description
Select to enable or disable Voice VLAN.
Enter the voice VLAN ID. The value is range from 1 to 4094.
Specify the priority of the voice VLAN from 0 to 7.
Enter the aging time of surveillance VLAN. The range is from 1 to
65535 minutes. The default value is 720 minutes. The aging time is
used to remove a port from voice VLAN if the port is an automatic
VLAN member. When the last voice device stops sending traffic and
the MAC address of this voice device is aged out, the voice VLAN
aging timer will be started. The port will be removed from the voice
VLAN after expiration of voice VLAN aging timer. If the voice traffic
resumes during the aging time, the aging counter will be reset and the
timer will stop.
Table 4.44
D-Link DMS-1100 Series User Manual
55