Timer Quiet (Radius Scheme View) - HP 5120 SI series Command Reference Manual

Description
Use the stop-accounting-buffer enable command to enable the device to buffer stop-accounting requests
getting no responses.
Use the undo stop-accounting-buffer enable command to disable the device from buffering
stop-accounting requests getting no responses.
By default, the device is enabled to buffer stop-accounting requests getting no responses.
Stop-accounting requests affect the charge to users. A NAS must make its best effort to send every
stop-accounting request to the RADIUS accounting servers. For each stop-accounting request getting no
response in the specified period of time, the NAS buffers and resends the packet until it receives a
response or the number of transmission attempts reaches the configured limit. In the latter case, the NAS
discards the packet. However, if you have removed the accounting server, stop-accounting messages are
not buffered.
Related commands: reset stop-accounting-buffer, radius scheme, and display stop-accounting-buffer.
Examples
# In RADIUS scheme radius1, enable the device to buffer the stop-accounting requests getting no
responses.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] stop-accounting-buffer enable

timer quiet (RADIUS scheme view)

Syntax
timer quiet minutes
undo timer quiet
View
RADIUS scheme view
Default level
2: System level
Parameters
minutes: Server quiet period in minutes, in the ranges from 0 to 255.
Description
Use the timer quiet command to set the quiet timer for the servers, that is, the duration that the status of
the servers stay blocked before resuming the active state.
Use the undo timer quiet command to restore the default.
By default, the server quiet period is 5 minutes.
You can use the command to adjust the duration during which a server must stay quiet, and control
whether the device changes the status of an unreachable server. For example, if you determine that the
primary server is unreachable because the device's port connected to the server is out of service
temporarily or the server is busy, you can set the server quiet period to 0 so that the device uses the
primary server whenever possible.
67