Reset Portal Connection Statistics - HP 5120 SI series Command Reference Manual

Parameters
port-number: Web proxy server port number, in the range of 1 to 65535.
all: Specifies all Web proxy server port numbers.
Description
Use the portal web-proxy port command to add the port number of a Web proxy server, so that HTTP
requests forwarded by the Web proxy server trigger portal authentication.
Use the undo portal web-proxy port command to delete one or all Web proxy server port numbers.
By default, no Web proxy server port number is configured on the device and proxied HTTP requests
cannot trigger portal authentication.
This command is only supported by Layer 2 portal authentication.
Up to four Web proxy server port numbers can be added.
If a user's browser uses the Web Proxy Auto-Discovery (WPAD) protocol to discover Web proxy servers,
you must add the port numbers of the Web proxy servers on the device, and configure portal-free rules
to allow user packets destined for the IP address of the WPAD server to pass without authentication.
You must add the port numbers of the Web proxy servers on the device, and make sure that their
browsers that use a Web proxy server do not use the proxy server for the listening IP address of the local
portal server. Thus, HTTP packets that the portal user sends to the local portal server are not sent to the
Web proxy server.
Examples
# Add Web proxy server port number 8080 on the device, so that users using a Web proxy server with
the port number can be redirected to the portal authentication page.
<Sysname> system-view
[Sysname] portal web-proxy port 8080

reset portal connection statistics

Syntax
reset portal connection statistics { all | interface interface-type interface-number }
View
User view
Default level
1: Monitor level
Parameters
all: Specifies all interfaces.
interface interface-type interface-number: Specifies an interface by its type and number.
Description
Use the reset portal connection statistics command to clear portal connection statistics on a specific
interface or all interfaces.
Examples
# Clear portal connection statistics on interface VLAN-interface 1.
<Sysname> reset portal connection statistics interface vlan-interface 1
160