Hwtacacs Scheme - HP 5120 SI series Command Reference Manual

Default level
2: System level
Parameters
ip-address: IP address in dotted decimal notation. It must be an address of the device and cannot be
0.0.0.0, 255.255.255.255, a class D address, a class E address, or a loopback address.
Description
Use the hwtacacs nas-ip command to specify a source IP address for outgoing HWTACACS packets.
Use the undo hwtacacs nas-ip command to remove the configuration.
By default, the source IP address of a packet sent to the server is the IP address of the outbound interface.
The source IP address of HWTACACS packets that a NAS sends must match the IP address of the NAS
that is configured on the HWTACACS server. An HWTACACS server identifies a NAS by IP address.
Upon receiving an HWTACACS packet, an HWTACACS server checks whether the source IP address of
the packet is the IP address of any managed NAS. If yes, the server processes the packet. If not, the server
drops the packet.
You can specify up to 16 source IP addresses.
NOTE:
The setting by the nas-ip command in HWTACACS scheme view is only for the HWTACACS scheme,
whereas the setting by the hwtacacs nas-ip command in system view is for all HWTACACS schemes. The
setting in HWTACACS scheme view takes precedence.
Related commands: nas-ip.
Examples
# Set the IP address for the device to use as the source address of the HWTACACS packets to 129.10.10.1.
<Sysname> system-view
[Sysname] hwtacacs nas-ip 129.10.10.1

hwtacacs scheme

Syntax
hwtacacs scheme hwtacacs-scheme-name
undo hwtacacs scheme hwtacacs-scheme-name
View
System view
Default level
3: Manage level
Parameters
hwtacacs-scheme-name: HWTACACS scheme name, a case-insensitive string of 1 to 32 characters.
Description
Use the hwtacacs scheme command to create an HWTACACS scheme and enter HWTACACS scheme
view.
75