Timer Realtime-Accounting (Hwtacacs Scheme View) - HP 5120 SI series Command Reference Manual

Parameters
minutes: Primary server quiet period, in minutes. It ranges from 1 to 255.
Description
Use the timer quiet command to set the quiet timer for the primary server, that is, the duration that the
status of the primary server stays blocked before resuming the active state.
Use the undo timer quiet command to restore the default.
Related commands: display hwtacacs.
Examples
# Set the quiet timer for the primary server to 10 minutes.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] timer quiet 10

timer realtime-accounting (HWTACACS scheme view)

Syntax
timer realtime-accounting minutes
undo timer realtime-accounting
View
HWTACACS scheme view
Default level
2: System level
Parameters
minutes: Real-time accounting interval in minutes, zero or a multiple of 3 in the range 3 to 60. A value
of zero means "Do not send online user accounting information to the HWTACACS server."
Description
Use the timer realtime-accounting command to set the real-time accounting interval.
Use the undo timer realtime-accounting command to restore the default.
By default, the real-time accounting interval is 12 minutes.
For real-time accounting, a NAS must transmit the accounting information of online users to the
HWTACACS accounting server periodically. This command is for setting the interval.
The setting of the real-time accounting interval somewhat depends on the performance of the NAS and
the HWTACACS server. A shorter interval requires higher performance. Use a longer interval when there
are a large number of users (more than 1000, inclusive).
Table 8 Recommended real-time accounting intervals
Number of users
1 to 99
100 to 499
500 to 999
Real-time accounting interval (minute)
3
6
12
88