Remote-Name - HP 5120 SI series Command Reference Manual

Use the undo remote-address command to remove the configuration.
The IP address configured with the remote-address command must match the local security gateway IP
address that the remote security gateway uses for IKE negotiation, which is the IP address configured with
the local-address command or, if the local-address command is not configured, the primary IP address
of the interface to which the policy is applied.
The local peer can be the initiator of IKE negotiation if the remote address is a host IP address or a host
name. The local end can only be the responder of IKE negotiation if the remote address is an address
range that the local peer can respond to.
If the IP address of the remote address changes frequently, configure the host name of the remote
gateway with the dynamic keyword so that the local peer can use the up-to-date remote IP address to
initiate IKE negotiation.
Related commands: id-type ip and local-address.
Examples
# Configure the IP address of the remote security gateway as 10.0.0.1.
<Sysname> system-view
[Sysname] ike peer peer1
[Sysname-ike-peer-peer1] remote-address 10.0.0.1
# Configure the host name of the remote gateway as test.com, and specify the local peer to dynamically
update the remote IP address.
<Sysname> system-view
[Sysname] ike peer peer2
[Sysname-ike-peer-peer2] remote-address test.com dynamic

remote-name

Syntax
remote-name name
undo remote-name
View
IKE peer view
Default level
2: System level
Parameters
name: Name of the peer security gateway for IKE negotiation, a string of 1 to 32 characters.
Description
Use the remote-name command to configure the name of the remote gateway.
Use the undo remote-name command to remove the configuration.
If you configure the id-type name or id-type user-fqdn command on the initiator, the IKE negotiation
initiator sends its security gateway name as its ID for IKE negotiation, and the peer uses the security
gateway name configured with the remote-name command to authenticate the initiator. Make sure the
local gateway name matches the remote gateway name configured on the peer.
Related commands: id-type, local-name, and ike local-name.
372