Aligning The Stator (Speed Measuring System) - HBM T10F KF1 Operating Manual

24
T10F
SUNSTAR传感与控制 http://www.sensor-ic.com/ TEL:0755-83376549 FAX:0755-83376182 E-MAIL:szss20@163.com

4.8 Aligning the stator (speed measuring system)

The stator can be installed in any position required (for example it can be
installed "upside down").
For measuring mode to operate perfectly, the slotted disc for the speed
measuring system must rotate at a defined position in the sensor fork.
Axial alignment
The sensor fork is provided with an alignment mark for axial alignment. In its
installed status the slotted disc must be positioned exactly over this alignment
mark. Variances of up to "2mm are permitted in measuring mode (total static
and dynamic displacement).
Slotted disc
Alignment mark
Fig. 4.6: Position of slotted disc in rotation speed sensor
NOTE
For fastening the stator we recommend M6 screws with packing
washers (elongated hole width 9 mm). Using this size of screw ensures
the necessary degree of mobility for alignment.
HBM B 23. T10F.90 en
SUNSTAR自动化 http://www.sensor-ic.com/ TEL: 0755-83376489 FAX:0755-83376182 E-MAIL:szss20@163.com