Installing The Stator B - HBM T10F KF1 Operating Manual

T10F
SUNSTAR传感与控制 http://www.sensor-ic.com/ TEL:0755-83376549 FAX:0755-83376182 E-MAIL:szss20@163.com

4.5 Installing the stator B

On delivery, the stator is installed and ready for operation. The antenna
segments can be separated from the stator, for example, for maintenance or
to facilitate stator installation. In order not to alter the central alignment of the
segment rings in relation to the stator foot, we recommend you remove only
one antenna segment from the stator.
If your application does not require stator disassembly, proceed as described
in sections 2., 6., 7. and 8.
Version with speed measuring system
Since the rotation speed sensor surrounds the slotted disc, it is not possible to
slide the stator axially over the ready–fitted rotor (except for the 50 N⋅m,
100 N⋅m and 200 N⋅m ranges). Please also note chapter 4.7 on this point.
Fig. 4.2: Antenna-segment screwed connections
1. Slacken and remove the screwed connections (M6) on one antenna
segment. Make sure that the serrated locking washers are not lost.
2. Use an appropriate foundation plate to install the stator housing in the
shaft run, in such a way that it is still possible to make horizontal and
vertical adjustments. Do not fully tighten the screws yet.
B 23.T10F.90 en
SUNSTAR自动化 http://www.sensor-ic.com/ TEL: 0755-83376489 FAX:0755-83376182 E-MAIL:szss20@163.com
19
HBM