Aligning The Stator (Speed Measuring System); Magnetic Speed Measuring System - HBM T10FS Mounting Instructions

Mechanical installation
38
5.9 Aligning the stator (speed measuring
system)
The stator can be mounted in any position (for example,
"upside down" installation is possible).
For measuring mode to operate perfectly, the speed
sensor (pole ring/slotted disc) of the speed measuring
system must be positioned at a defined point to the
sensor.
Notice
To attach the stator, we recommend the use of M6
screws with plain washers (width of oblong hole, 9 mm).
This size of screw guarantees the necessary travel for
alignment.
5.9.1

Magnetic speed measuring system

Notice
With the magnetic speed measuring system, the stator
pole ring and stator sensor head are perfectly matched to
each other. To maintain the specified pulse quality, the
transducer components provided in multiple deliveries
must not be mixed up. Before installation, compare the
identification numbers of the rotor and stator (also see
note on Page 24)!
A0785-150 HBM: public
T10FS