T10F
SUNSTAR传感与控制 http://www.sensor-ic.com/ TEL:0755-83376549 FAX:0755-83376182 E-MAIL:szss20@163.com
4.7 Installing the slotted disc (speed measuring system)
The slotted disc for the speed measuring system is not fitted to the rotor in
order to avoid damage in transit. It must be fastened to the adapter flange (or
intermediate flange) before installing the rotor in the shaft run. The associated
rotation speed sensor is already fitted to the stator.
The necessary screws, screwdriver and screw lock are included among the
components supplied.
Fig. 4.5: Installing the slotted disc
CAUTION
When carrying out any installation work, make sure that the slotted disc
is not damaged.
Assembly sequence
1. Slide the slotted disc onto the adapter flange (or auxiliary flange) and align
the screw holes.
2. Put the screw lock a little way onto the screw thread and tighten the
screws (tightening torque < 15 N⋅cm).
B 23.T10F.90 en
SUNSTAR自动化 http://www.sensor-ic.com/ TEL: 0755-83376489 FAX:0755-83376182 E-MAIL:szss20@163.com
Slotted disc
Fastening screw
for slotted disc
turned in the cutting plane
Intermediate flange (50 N⋅m and
100 N⋅m only)
23
HBM