Locating The Gps Antenna - Symmetricom TimeProvider 1000 User Manual

Edge clock
Hide thumbs Also See for TimeProvider 1000:
Table of Contents

Advertisement

Prior to installing the antenna, the site, antenna location, lightning suppressor
location, cable route, and all other details should be planned. Use
guide to locating the antenna.
Figure 3-17. Locating the GPS Antenna
To install the antenna, refer to
section. Ensure all user-supplied materials are available. The minimum distance
between the antenna and the shelf is 20 feet (6 m); the maximum distance between
the antenna and the shelf is 1000 feet (304 m).
Warning: To prevent arcing, ensure that the lightning suppressor is
installed away from electrical devices and cabling.
Note: Use the following antenna installation instructions as a
guideline only. Install the antenna using company-approved
techniques, and follow all appropriate local building and electrical
codes.
Recommendation: The TimeProvider uses an antenna that requires
a minimum cable length of 20 feet (6 m) from the antenna to the
TPIU. Symmetricom recommends that you adhere to this minimum
length requirement to ensure proper antenna operation.
097-58001-02 Revision C – August 2005
Figure
3-18, and perform the procedure in this
Chapter 3 Installing the TimeProvider
Making Connections
Figure 3-17
TimeProvider User's Guide
as a
65

Advertisement

Table of Contents
loading

This manual is also suitable for:

Timeprovider 1100

Table of Contents