Using Alarm Codes To Troubleshoot - Symmetricom TimeProvider 1000 User Manual

Using Alarm Codes to Troubleshoot

Table 6-7 lists the alarm codes generated by the TimeProvider. Unless specified,
each alarm has a default Error Delay of Immediate, and you cannot edit the Error
Delay.
Table 6-7. Alarms
Alarm ID
Alarm Condition
Or
Description
CONDTYPE
COMPAT System components
(hardware and software)
are not compatible
EXTALM1 The external alarm used
to monitor alarms
generated by external
equipment.
EXTALM2 The external alarm used
to monitor alarms
generated by external
equipment.
EXPNEQPT The Expansion panel
was physically inserted
or removed from the
system.
PWRA The IMC has detected
the loss of power on the
A connection
PWRB The IMC has detected
the loss of power on the
B connection.
IOC1EQPT The IOC was physically
inserted or removed
from the system.
IOC2EQPT The IOC was physically
inserted or removed
from the system.
OUTAEQPT Output module A was
physically inserted or
removed from the
system.
097-58001-02 Revision C – August 2005
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Error
AID Service
Delay
TYPE Affecting
Default
<aid> = SYS
EQPT NSA IMMED
EQPT NSA IMMED
EQPT NSA IMMED
EQPT NSA IMMED
EQPT NSA IMMED
EQPT NSA IMMED
EQPT NSA IMMED
EQPT NSA IMMED
EQPT NSA IMMED
Troubleshooting the TimeProvider
Alarm Default
Error
Level
Delay
Editable
SSU PRS SUB
NO MJ MJ
NO MJ MJ
NO CR CR
NO MJ MJ
NO MJ MJ
NO MJ MJ
NO MJ MJ
NO MJ MJ
NO MJ MJ
TimeProvider User's Guide 167
MJ
MJ
CR
MJ
MJ
MJ
MJ
MJ
MJ