Symmetricom TimeProvider 1000 User Manual page 172

Chapter 6 Maintaining and Troubleshooting the TimeProvider
Troubleshooting the TimeProvider
Table 6-7. Alarms (Continued)
Alarm ID
Alarm Condition
Or
Description
CONDTYPE
MTIE Input has exceeded at
least one of the MTIE
alarm thresholds.
TPIUSIG TimeProvider Composite
Timing Signal interface is
not functioning.
INPDISQ The specified input was
Disqualified or Qualified
as a possible system
reference. The fault
condition must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPDISQ is set,
the alarm clears when
the input signal is fault
free for the Clear Delay
Time (CLRDELAY).
INPLOS The specified input port
has Loss Of Signal.
When LOS is detected,
the input is immediately
removed from the
possible reference list.
The LOS must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPLOS is set, the
alarm clears when the
input signal is LOS free
for the Clear Delay Time
(CLRDELAY).
172 TimeProvider User's Guide
Error
AID Service
Delay
TYPE Affecting
Default
T1 NSA IMMED
T1 NSA IMMED
<aid> = PRS
T1 NSA FLT
DELAY
T1 NSA IMMED
Alarm Default
Error
Level
Delay
Editable
SSU PRS SUB
NO MN MN
NO MN MN
YES MN MN
NO MN MN
097-58001-02 Revision C – August 2005
MN
MN
MN
MN