Event Code Conditional Descriptions - Symmetricom TimeProvider 1000 User Manual

Table 6-7. Alarms (Continued)
Alarm ID
Alarm Condition
Or
Description
CONDTYPE
S1LOS LOS on Side 1
S2LOS LOS on Side 2
EXSLIP Excessive slip rate
RTMFAULT The IOC cannot
determine if the Retimer
is functioning properly.
Table 6-8 lists each event and describes the conditions that generate the associated
event.
Table 6-8. Event Code Conditional Descriptions
Event ID
ACCLVL User access level has changed
ACO Audio alarm is deactivated
ACCLVL User access level has changed
ACO Audio alarm is deactivated
ALMCHG Alarm parameter has changed, <keyword>,<alarm>
AOMERGE Autonomous event reporting has changed, <state>
BAUD Serial baud rate has changed, <value>
CMDCHG Command access level has changed, <command>
ECHO Serial port echo mode has changed, <state>
FLOW Serial flow control has changed, <state>
FWFAIL Firmware upgrade unsuccessful
FWOK Firmware upgrade successful
FWLOAD Beginning firmware upgrade
IMCBIST Built-in self test, <value>
INITLOG Event log has been cleared
IPADDR IP address has changed, <value>
097-58001-02 Revision C – August 2005
Chapter 6 Maintaining and Troubleshooting the TimeProvider
Error
AID Service
Delay
TYPE Affecting
Default
<aid> = RTMg[-p]
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
Event Conditional Description
IMC Event Conditions
Troubleshooting the TimeProvider
Alarm Default
Error
Level
Delay
Editable
SSU PRS SUB
NO MN MN
NO NA NA
NO NA NA
NO NA NA
TimeProvider User's Guide 177
MN
NA
NA
NA