Making Output Connections; Output Connector Modules; Pinout For The Db9 Output Module - Symmetricom TimeProvider 1000 User Manual

Chapter 3 Installing the TimeProvider
Making Connections

Making Output Connections

You make the output signal connections using one of the Output modules listed in
Table 3-4. Attach the module to the shelf before you connect cables.
Table 3-4. Output Connector Modules
Item Number
090-58091-01
090-58091-02
090-58091-03
090-58091-04
090-58091-05
090-58091-06
090-58081-02
090-58082-01
090-58082-06
Installing the Output Module
Attach the Output module to the shelf and secure it using the screws at the top and
bottom of the module.
Table 3-5 lists the pinout for the DB9 Output module, which is shown in
Table 3-5. Pinout for the DB9 Output Module
Pin
1
2
4, 5, and 6
8
9
60 TimeProvider User's Guide
Description
BNC Output module
Wire-wrap Output module
DB9 Output module
SMZ/BT43 Output module
Metric (Siemens) 1.0/2.3 Output
module
Metric (Siemens) 1.6/5.6 Output
module
T1 Retimer Output module (wire-wrap)
E1 Retimer Output module (BNC)
E1 Retimer Output module (Siemens
1.6/5.6)
Description
Port A Tip
Port A Ring
Chassis Ground
Port B Tip
Port B Ring
Reference
Figure 3-12
Figure 3-12
Figure 3-13
Figure 3-13
Figure 3-14
Figure 3-14
Figure 3-14
Not shown
Not shown
Figure
097-58001-02 Revision C – August 2005
3-13.