Setting The Gps Parameters - Symmetricom TimeProvider 1000 User Manual

Chapter 4 Provisioning the TimeProvider
Provisioning the Input Reference
Autonomous Message
A 1178 REPT EVT
HAS CHANGED,MONITOR\""
;

Setting the GPS Parameters

After you install the GPS antenna, you must provision the parameters using the
ED-EQPT command.
ED-EQPT:[<tid>]:<aid>:[<ctag>]::<keyword>=<value>;
This command has a default access level of ADMIN.
<aid> <keyword>
GPS
MODE
POS
Note: The
position can
only be set
when Mode
is MANUAL
ELEVMASK
Sample Command
ED-EQPT::GPS:TS1000::MODE=AUTO;
This command sets the GPS location mode to Automatic. The location of the GPS
antenna is determined from multiple satellite fixes.
100 TimeProvider User's Guide
TP-SSU 03-10-24 10:44:21
"INP1,T1:NA,INSTATE,NSA,03-10-24 10-44-21:\"INPUT STATE
<value>
GPS input, except clock input
signals
AUTO The antenna position (latitude,
longitude, and elevation) is
automatically computed or
recomputed and set
MANUAL The position (latitude, longitude,
and elevation) is set manually using
the POS keyword
LAT dd-mm-ss.ssN or
dd-mm-ss.ssS
LONG dd-mm-ss.ssE or
dd-mm-ss.ssW
ELEV hhhh.hh height in m
5 to 45 The elevation mask, below which
the TimeProvider will not track or
acquire a satellite
Description
097-58001-02 Revision C – August 2005
Default value
AUTO
n/a
10