Clock Performance; Output Signals - Symmetricom TimeProvider 1000 User Manual

Chapter 1 Overview of the TimeProvider

Clock Performance

Clock Performance
Two IOCs are available:
A Rubidium-based version that meets ST2/Type II standards. This IOC meets or
exceeds the ITU G.812 Type II specification.
A Quartz-based version that meets ST3E/Type I standards. This IOC meets or
exceeds the ST3E requirements in ANSI T1.101 and Telcordia GR-1244, as well
as the ITU-T G.812 TYPE III specification and ITU-T G.812 Type I specification.

Output Signals

The main shelf has 32 output connections arranged in four groups of eight outputs;
using the optional Expansion Panel, you can expand to 64 outputs. The outputs are
"universal," and can supply E1, 2.048 MHz, T1, 8 kHz, CC, JCC, JCC4, 1.544 MHz,
and 6.312 MHz signals. E1 and T1 signals can be provisioned with standard framing
and G.703 formats. You provision the outputs in groups of eight outputs (or 16
outputs if the optional Expansion Panel is installed).
The TimeProvider use interchangeable Output modules, allowing you to select the
connector and termination impedance. Output modules are available with the
following connectors:
BNC – 75 Ω
DB9 – 120 Ω
Metric (Siemens) 1.6/5.6 – 75 Ω
Metric (Siemens) 1.0/2.3 – 75 Ω
Wirewrap – 100 Ω
BT43 – 75 Ω
Each Output module plugs into the shelf (and Expansion Panel) and provides
connectors and terminations for eight outputs. Make the output connections using
the procedures described in
the output signal type using the software commands described in
Outputs, on page 111.
36 TimeProvider User's Guide
Making Output Connections, on page 60. You provision
Provisioning the
097-58001-02 Revision C – August 2005