Chapter 5 Testing the TimeProvider
Testing the TimeProvider
Testing the TimeProvider
Perform the tests described in this chapter after you install (see
the
TimeProvider) and provision (see
TimeProvider. Record the results in the Test Record in
These tests verify the operation of the TimeProvider and are not mandatory for
operating the unit.
Test Overview
This chapter describes four tests that verify the operation of the TimeProvider:
Verify normal operation
Test alarm conditions
Test communication ports
Perform output checks
Test Equipment
To perform the tests in this chapter, you need the following equipment:
Volt-ohmmeter
Oscilloscope
Communications analyzer
Verifying Normal Operation
The LEDs on the IMC and the IOC(s) indicate the status of the TimeProvider.
5-1
shows the condition of the LED indicators on the front panel of the IOC under
normal operating conditions.
Table 5-1. LED Conditions for the IOC
LED Name
Power
Fail
Alarm
Active
136 TimeProvider User's Guide
Chapter 4, Provisioning the
Condition
Green
Off
Off
Green
Off
Chapter 3, Installing
TimeProvider) the
Test
Record, on page 143.
Description
Power is On
No failure
No alarm
Card is active
Card is in standby mode
097-58001-02 Revision C – August 2005
Table