Installing The Antenna Bracket On A Pipe; Installing The Antenna Bracket On A Post - Symmetricom TimeProvider 1000 User Manual

To install the antenna:
1. Attach the antenna mounting bracket to a 1-inch (2.5 cm) diameter pipe or wood
post.
– If you are mounting the bracket to a pipe, assemble as shown in
Figure
bracket slots; then place the provided four washers and four nuts over the
V-bolts, against the mounting bracket. Leave the V-bolts loose enough to
allow for final adjustments.
Figure 3-19. Installing the Antenna Bracket on a Pipe
– If you are mounting the bracket to a wood post, assemble as shown in
Figure
positioned mounting bracket slots, and attach to the post.
Figure 3-20. Installing the Antenna Bracket on a Post
Mount the antenna and mast assembly to the "L" bracket.
097-58001-02 Revision C – August 2005
3-19. Slide the two V-bolts over the pipe, and through the mounting
3-20. Install the provided two self-tapping screws in two diagonally
Chapter 3 Installing the TimeProvider
Making Connections
TimeProvider User's Guide 67