Brick Settings - Sony MVS-8000 User Manual

Note
It is not possible to make images intersect. If an image is rotated, the priority is
determined by the position on the z-axis of the center of the image.

Brick Settings

This effect creates a rectangular parallelepiped from 3 successive channels.
For an illustration, see "Global Effects" in Chapter 1 (Volume 1).
Applying the Brick effect
Use the following procedure.
1
In the Global Effect>Ch1 - Ch4 menu, select HF2 'Brick.'
The Brick menu appears.
2
Press [Brick], turning it on.
The Brick effect is enabled, and a rectangular parallelepiped (brick)
showing the images of three channels appears. You can use the knobs to
adjust parameters for the height of the brick and the overlap between the
three images.
Note
When the Brick effect is enabled, the z-axis position of the front image in
the source coordinate frame is shifted by the amount of half the height.
Therefore, the image is somewhat magnified.
3
Set the parameters.
Knob
1
2
3
4
a) Setting for SD 4:3, SD 16:9
b) Setting for HD 4:3, HD 16:9
Parameter
Height
Front Overlap
Side H Overlap
Side V Overlap
Adjustment Setting values
Height of brick
0.00 to 8.00
0.00 to 32.00
−
Front overlap
100.00 to +100.00
−
Side H overlap
100.00 to +100.00
−
Side V overlap
100.00 to +100.00
Global Effect Operations
a)
b)
85