Sony MVS-8000 User Manual page 256

Selecting the processing order of masks and borders
In the <Mask/Border Process> group of the Switcher>Key/Wipe/FM menu,
select one of the following.
Mask>Border: Apply the mask effect, then apply the border effect.
Border>Mask: Apply the border effect, then apply the mask effect.
Selecting the key priority operation mode
In the <Key Priority> group of the Switcher>Key/Wipe/FM menu, select one
of the following.
Normal: The key priority sequence can be varied freely.
Fix: Fixed at currently set priority sequence.
Setting the operation mode of the key bus [XPT HOLD] button
In the <Xpt Hold Mode> group of the Switcher>Key/Wipe/FM menu, select
any of the following.
Key Disable: The [XPT HOLD] button of the key bus functions as a key
Xpt Hold: The [XPT HOLD] button of the key bus functions as a cross-point
Setting the operation mode when the pattern limit is released
In the <Pattern Limit Transition> group of the Switcher>Key/Wipe/FM menu,
select either of the following operation modes.
Auto: When the pattern limit is released, the remainder of the transition is
Manual: After the pattern limit is released, the transition waits for the next
Setting the default wipe edge softness
Use the following procedure.
In the Switcher>Key/Wipe/FM menu, adjust the following parameter to set the
default value.
Knob
3
256
Setup Relating to Switcher Processor
disable button. When the [XPT HOLD] button is on, recalling a snapshot
or keyframe effect does not reflect the key settings, including the cross-
point selection information.
hold button. When the [XPT HOLD] is on, recalling a snapshot or
keyframe effect does not reflect the cross-point selection information.
carried out automatically at a special-purpose transition rate.
operation, then executes. Until you move the fader lever or press [AUTO
TRANS], the transition is not executed.
Parameter Adjustment
Wipe Edge Default value of wipe edge softness
Soft
Setting values
–
50.00 to +50.00