Sony MVS-8000 User Manual page 76

Note
When you turn on keyframe strobe, if the trail or motion decay effect is on, it
automatically goes off.
Leaving a trail of afterimages of the image
Use the following procedure.
1
2
3
4
Selecting the overlay priority for movie and still images (video
freeze image)
In the <Priority> group, select the way in which the images are overlaid.
Over: the movie is on top, and the still image is underneath.
Under: the movie is underneath, and the still image is on top.
Mix: the movie and still images are mixed; adjust the following parameter with
Selecting the freeze timing
In the <KF Freeze Timing> group, select the timing for freezing the keyframe
strobe.
76
DME Special Effect Operations
In the DME menu, select VF5 'Light/Trail' and HF4 'KF Strobe.'
The KF Strobe menu appears.
Press [KF Strobe], turning it on.
This enables the keyframe strobe effect, and you can now use the knobs to
adjust the parameters.
Set the following parameter.
Knob Parameter Adjustment
1 Decay Degree of blurring of the video
signal
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the afterimage does not
decay.
To erase the afterimage, press [KF Strobe Eraser], turning it on.
the knob.
Knob Parameter Adjustment
1 Mix Mix amount of the still image with
respect to the movie
a) The 0.00 setting is the same as Over, and the 100.00 is the same as Under.
Setting values
a)
0.00 to 100.00
Setting values
a)
0.00 to 100.00