Sony MVS-8000 User Manual page 24

Adding a border
Use the following procedure.
1
2
3
24
DME Special Effect Operations
In the DME menu, select VF1 'Edge' and HF1 'Border/Crop.'
The Border/Crop menu appears.
Press [Border], turning it on.
The Border effect is enabled. You can adjust the border width parameters
with the knobs.
Note
Once the Border effect is enabled, you cannot use the Edge Soft effect (see
page 28).
Set the parameters.
Parameter limits vary as shown below, depending on the signal format (SD
or HD) and aspect ratio (4:3 or 16:9) selected in the system.
• SD format, 4:3 mode
Knob Parameter
1 H
2 V
3 All
5 Density
6 Top
7 Left
8 Right
9 Bottom
10 Density
• SD format, 16:9 mode
Knob Parameter
1 H
2 V
3 All
Adjustment
Border width on left and right
sides
Border width on top and bottom
sides
Border width on all sides
Border density
Border width on top side
Border width on left side
Border width on right side
Border width on bottom side
Border density
Adjustment
Border width on left and right
sides
Border width on top and bottom
sides
Border width on all sides
Setting values
Left value shown
Top value shown
Left value shown
0.00 to 100.00
−6.00 to +6.00
−
8.00 to +8.00
−
8.00 to +8.00
−
6.00 to +6.00
0.00 to 100.00
Setting values
Left value shown
Top value shown
Left value shown