Sony MVS-8000 User Manual page 167

Note
In the numeric keypad control block, it is not possible to apply the cross-
point hold and GPI output attributes. For these, see "Applying snapshot
attributes" (page 176).
7
Press the [ENTER] button.
This saves the snapshot, and the [STORE] button goes off. The [RCALL]
and [STORE STATS] buttons light.
To cancel a snapshot save operation
After saving a snapshot, to cancel the save, hold down the [STORE STATS]
button and press the [UNDO] button.
Recalling a snapshot from the numeric keypad control block
Use the following procedure.
1
In the numeric keypad control block, press the [SNAPSHOT] button,
turning it on.
This allocates the numeric keypad control block to snapshot operations,
and the [RCALL] button lights.
2
Press the region selection button corresponding to the region you want to
recall, turning it on. Multiple selections are also possible.
[M/E 1], [M/E 2], [M/E 3], [P/P]: Select the M/E-1, M/E-2, M/E-3, or
PGM/PST region respectively.
[USER 1] to [USER 8]: Select a user region.
[DME 1] to [DME 8]: Select a DME channel.
[ALL]: Select all regions together.
[MASTR]: Select a master snapshot.
Note
The regions that can be selected simultaneously are those assigned to the
region selection buttons in the numeric keypad control block. (See
"Assigning the region selection buttons in the numeric keypad control
block" (page 217).)
It is not possible to select [MASTR] and other regions simultaneously. If
selected simultaneously, the master snapshot takes precedence.
The first pressed button lights green as the reference region, and
subsequently pressed buttons light amber.
For details of the precedence order for becoming the reference region, see
"Regions and registers" in Chapter 1 (Volume 1).
Snapshot Operations From the Numeric Keypad Control Block
167