Sony MVS-8000 User Manual page 259

3
To confirm the selection, press [Link Src Set].
This links the link destination signal to the signal selected as Main No.
To initialize the set source address
Press [Init Link Table].
A confirmation message appears; press [Yes].
The source addresses are reassigned, and this is reflected in the status area.
To change the link number and link table number
In this menu too, you can change the link number and link table number. To do
this, turn the knobs as follows to make the setting, then press [Link Table Set].
Knob
1
3
Linking cross-point buttons and GPI output ports
To link cross-point buttons or the [CUT] and [AUTO TRANS] buttons in the
cross-point control block, and GPI output ports, use the following procedure.
1
In the Switcher>Link menu, press [GPI Link], to display the
Switcher>Link>GPI Link menu.
The status area shows the output ports and the link status, and delay value
information.
2
Using any of the following methods, select the GPI output port.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the setting.
Knob Parameter
1
3
Press [GPI Link Adjust].
The GPI Link Adjust menu appears.
The status area shows the current setting state of the selected link, and a
list of the selectable video names or button names, together with the GPI
link Enable/Disable setting for each bus.
Parameter Adjustment
Link No Link to which setting applies
Link Table No Link table selection
Adjustment
GPI Port GPI output port selection
Setting values
1 to 64
1 to 8
Setting values
1 to 8
Setup Relating to Switcher Processor
259