The status area shows the status of the currently selected matrix, and a list
of the source and destination start addresses that can be selected.
In this menu too, you can use the knobs to select the link for the setting.
2
Using any of the following methods, define the position of the matrix to be
linked.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
Knob
Parameter
2
Source
3
Destination
4
Level
3
To confirm a source address selected in step 2, press [Source Set] to
confirm a destination address press [Destination Set], and to confirm a
level press [Level Set].
This confirms the selection, which is reflected in the status area.
To set a link table
For the link selected in the External Bus Link menu, make the settings as
follows.
1
In the Panel>Config>External Bus Link>Link Matrix Adjust menu, press
[Link Table Adjust].
The Link Table Adjust menu appears.
The status area lists the status of the currently selected link, combinations
of video signals and sources, and the sources that can be selected.
2
Using any of the following methods, select the switcher cross-point button
and the matrix source to be linked to the button.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the selection.
Knob
Parameter
1
Main No
2
Source No
Adjustment
Source start address
Destination start address
Level
Adjustment
Switcher cross-point button
Matrix source selection
Setup Relating to Operations From the Control Panel
Setting values
1 to 897
1 to 897
1 to 8
Setting values
1 to 128
1 to 128
215