Sony MVS-8000 User Manual page 168

3
4
5
To cancel a snapshot recall operation
After saving a snapshot, to cancel the recall, press the [UNDO] button.
168
Snapshot Operations From the Numeric Keypad Control Block
The display shows the name of the reference region and the number of the
register previously recalled for that region.
Enter the desired register number from the numeric keypad.
See step 5 (page 166) in "Saving a snapshot from the numeric keypad
control block."
The entered register number appears in the display.
To apply temporary attributes, press the following buttons, turning them
on.
Control block Temporary
attribute to apply
Cross-point control A/B bus cross-point
block hold
Key cross-point hold [XPT HOLD] button in the key bus
Key disable
Numeric keypad Effect dissolve
control block
Auto transition
a) When Xpt Hold mode is selected in setup.
b) When Key Disable mode is selected in setup.
For details of temporary attributes and available attributes, see "Snapshot
Attributes" in Chapter 1 (Volume 1).
Notes
• The cross-point hold and key disable settings are maintained until you
next press the [XPT HOLD] button.
• Applying temporary attributes does not affect the contents of the
register.
• It is not possible to apply temporary attributes to a master snapshot.
Press the [ENTER] button.
This recalls the specified snapshot, and the reference region name and
recalled register number appear in the display.
If you applied the effect dissolve or auto transition temporary attributes in
step 4, the corresponding buttons go off.
When a master snapshot is recalled, the region selection buttons light
according to the saved region information.
Button
[XPT HOLD] button in the
background A/B bus
[XPT HOLD] button in the key bus
[+/−/EFF DISS] button
[CLR/AUTO TRANS] button
a)
b)