Sony MVS-8000 User Manual page 260

4
5
6
7
To set the delay value
Use the following procedure.
1
260
Setup Relating to Switcher Processor
Using any of the following methods, select what the setting applies to. For
each GPI port there can be up to eight links.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the selection.
Knob Parameter
1 GPI Port
2 Link No
3 Video/Button No Video or button name
a) These include main pair numbers 1 to 128, and "Cut" and "Auto Trans" on each operating
bank.
In the <Video/Button> group, press [Select].
The selected video or button name is reflected in the status area.
To clear a video/button name link
Make the selection to which the setting applies, then in the <Video/
Button> group press [Clear].
To select for each bus whether the GPI link setting is enabled or disabled,
use any of the following methods to select the bus to which the setting
applies.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob to make the selection.
Knob Parameter
4 Bus
In the <Bus> group, select any of the following.
Enable: Enable the GPI link setting for the selected bus.
Disable: Disable the GPI link setting for the selected bus.
All Enable: Enable the GPI link setting for all buses.
In the GPI Link Adjust menu, turn the knobs to select the output port for
which you want to set the delay value, and the corresponding delay value.
Adjustment
GPI output port selection
Link number selection
selection
Adjustment
Bus selection
Setting values
1 to 8
1 to 8
a)
1 to 136
Setting values
1 to 112