Remc3 Carrier Modulation Control Register - Epson S1C17M20 Technical Manual

17 IR REMOTE CONTROLLER (REMC3)

REMC3 Carrier Modulation Control Register

Register name Bit
REMCCTL 15–9 –
8
7–1 –
0
Bits 15–9 Reserved
Bit 8 OUTINVEN
This bit inverts the REMO output polarity.
1 (R/W): Inverted
0 (R/W): Non-inverted
For more information, see Figure 17.4.3.1.
Bits 7–1 Reserved
Bit 0 CARREN
This bit enables carrier modulation.
1 (R/W): Enable carrier modulation
0 (R/W): Disable carrier modulation (output data signal only)
Note: When carrier modulation is disabled, the REMDBCTL.REMOINV bit should be set to 0.
17-12
Bit name Initial
0x00
OUTINVEN 0
0x00
CARREN 0
Seiko Epson Corporation
Reset R/W
– R –
H0 R/W
– R
H0 R/W
S1C17M20/M21/M22/M23/M24/M25
Remarks
TECHNICAL MANUAL (Rev. 1.0)