On Options; Home Options - Strand Lighting NEO User Manual

User's Manual
Left to Right will leave the fist fixture unchanged and fan all of the other fixtures out from the first value.
Right to Left will leave the last fixture unchanged and fan all of the other fixtures in from the last value.
Middle out will cause the middle fixture to remain unchanged and fixture either side of it to fan appropriately.
Crossed is a mixture of middle out and outside in. Each alternative fixture will be either middle out or outside in.
Outside in will cause both the first and last fixtures to remain unchanged while the fixtures in between are
proportionally adjusted towards a center value.
Hi Light - applies the Hi Light values to the selected fixtures. The purpose of Hi Light is to clear out the beam of a
fixture so that it can be identified on a visually contaminated stage.
The value that each fixture is set to when hi-light is active can be defined in the fixture library. For most attributes this
is the same as the home value.
Highlight is a toggle option in NEO so that once you have identified the fixtures pressing the button again will return
you to the previous stage look.

ON Options

Rem Dim (Solo) - this turns off all non-selected fixtures.
"Hi Light" Selection Mode - when mode is selected (button text is red) sets selected fixture to its "hi light" mode.
The specifics of the hi light mode is determined by the settings in the fixture within the fixture library editor.
Full - takes selected fixture to 100%.
Lamp On - runs the lamp strike function to the selected fixture.
Lamp Off - runs the lamp douse function to the selected fixture.
Fixture Reset - runs the lamp reset function to the selected fixture.
The Lamp On/Off/Reset is an automated version of selecting the fixtures, taking the control channel to Lamp On/
Lamp Off/Fixture Reset, holding for 3 to 5 seconds and then placing the control channel back to idle.

Home Options

Command Line solutions here is press and hold the [HOME] key and then press
the [Attribute Family] button.
+
Intensity - sets selected fixtures to the default intensity value.
+
Position - sets selected fixtures to the default position value.
+
Color - sets selected fixtures to the default color value.
+
3 6
Software Configuration