Set Auto Mark; Include Running Effects; Include Submasters; Include Palettes And Presets - Strand Lighting NEO User Manual

User's Manual
Tracking - will store the information normally (instruction or tracked value) in this cue and all changed values will
continue down the cue list until each fixture's attribute hits another instruction. This means that the light will stay
where it is until it gets an instruction to do something else. This occurs per attribute.
Trackback - will store the information normally (instruction or tracked value) and will go back up the cue list, in
reverse order until each values gets another instruction. This is tracking back up the cue list.

Set Auto Mark

Auto Mark will prepare the moving lights for their next use before they are needed. This happens automatically and is
calculated by the NEO console.
The options are...
None - meaning that the NEO console will not auto mark when running cues.
Mark as early as possible - will mark for the next use as soon as the lights go to 0 intensity.
Mark as late as possible - will mark for the next use in the cue previous to the next use .

Include Running Effects

If an effect is running while a cue is being recorded, this feature will determine if the running effect is stored to be
triggered by the cue. This feature is turned on by default.

Include Submasters

If any channels/fixtures are being controlled by a submaster (levels in yellow), this feature will determine if the action
of Recording will include those levels when stored. This feature is turned off by default.

Include Palettes and Presets

If any channels/fixtures are being controlled by palettes or focus groups, this feature will determine if the action of
recording will include those palette or focus group references. If not, then the cue will hold raw data. This feature is
on by default.

31. Intermediate Options

These are show defaults that may need to be adjusted for more than basic operation. However, most of them are likely
set and forget.
Make cue active after record - When this option is selected the cue that was just recorded or updated will
automatically become the active cue.
Release channels after Record/Update - when this option is on and a cue is recorded or updated, the channels/
fixtures will be released to the cue.
Release set channels on cue go - When you press "cue go" the system will release all channels not being controlled
by cues before running the next cue.
Force Fixture Block - when this option is on and attribute information is stored in a Cue/Group/FX, any attribute that
is changed will force the entire fixture to be recorded.
1 8 0
Software Configuration