Table of Contents
Advertisement
User's Manual
Profile Effect Options
Submaster - Assigning a submaster to the playback will override the dimmer of the fixtures contained in the effect.
As the effect runs the position of the submaster will determine output of the fixtures.
Playback - Assigning a playback will disable the submaster edit as only one can be assigned to the FX playback at a
time. A playback relates to the Enttec Playback wing. Assigning a playback does more than just utilize the fader on
the wing but also allows you to use the play, back and pause buttons to run the effect.
Start/Stop Shortcut - Set a shortcut number to assign to the playback controls for this playback. Pressing the shortcut
will start the effect running. Pressing the shortcut while the effect is running will pause the effect and pressing it twice
within 2 seconds will rewind the effect to the start.
Override Effect Length - Set this field to change the length that the effect will run for. If this value is set to 0, the
default length (Set during creation of the effect) will be used.
Loop Continuously - Check this option to make the effect loop back to the start when it finishes. If this option is not
checked then it will stop as soon as the effect ends.
Scale Submaster - Assign a submaster to this field to manually adjust the scale parameter of the effect while it is
running. This can provide a dynamic way to vary the effect.
Offset Submaster - Assign a submaster to this field to manually adjust the offset parameter of the effect.
Stagger Direction - Use this drop down option to specify how stagger will operate on the list of fixtures.
• Forward - The stagger will be spread across the fixtures starting at the first fixture.
• Backward - This is the opposite of the forward stagger as the fixtures will be staggered from the last one through
to the first.
• Bounce - Each time the effect runs the direction of the stagger will alternate between forward and backward
behavior.
• Random - The fixtures in the effect will have a random order and the stagger applied over the new order.
1 6 0
Software Configuration
Advertisement
Table of Contents
Need help?
Do you have a question about the NEO and is the answer not in the manual?
Questions and answers
Replugged the monitor in to NEO ;ighting console and now touchscreen function does not work and need a solution to fix. Cable in plugged in all of the way.
To fix the touchscreen function on the Strand Lighting NEO console after replugging the monitor, follow these steps:
1. Go to the Touchscreen Calibration option in the settings.
2. Click on Setup and follow the on-screen instructions to identify the touchscreen.
3. If the touchscreen is not functioning correctly, press the Calibrate button.
4. Follow the on-screen instructions to complete the calibration.
5. You may need to touch the screen multiple times until it gathers enough data.
This should restore touchscreen functionality.
This answer is automatically generated