Dmx512 Output; Midi/Smpte; Console Power Up Procedure - Strand Lighting NEO User Manual

User's Manual
To connect console components, do the following:
Step 1. At console rear panel, IEC power cable (included).
Step 2. Connect monitor(s)* or touchscreen(s)*.
Step 3. Install gooseneck lamps (included).
*Optional accessories sold separately.

3. DMX512 Output

The console provides four standard XLR 5-pin connectors for connecting to DMX512 devices. Each connector
supports one DMX512 universe of 512 DMX channels. Connect DMX512 devices as shown in Figure 1.

4. MIDI/SMPTE

The NEO has the capability to both send and receive MIDI and SMPTE time code.

5. Console Power Up Procedure

Once the console has been installed and all components connected, the console and processor can be powered up.
To power up:
Step 1. At back of console, toggle the power switch to on.
Step 2. After boot up is complete, go into System Properties and set the system to work to your preferences. See
Quick Start Guide for guidance.
Step 3. While in "System Properties," verify that other important and systemic features are set correctly for you.
• System Settings
• Show Defaults
2 2
Installation and Setup