Before Putting The Power Source Into Service; Safety; Utilisation For Intended Purpose Only; Machine Set-Up Regulations - Fronius TransPocket 1100 Operating Instructions Manual

Before putting the power source into service

Safety

The power source is intended to be used SOLELY for rod electrode welding.
Utilisation for
Any other use, or any use going beyond the above, is deemed to be "not for the intended
intended purpose
purpose" and the manufacturer shall not be liable for any damage resulting therefrom.
only
"Utilisation for the intended purpose" shall also be deemed to encompass:
-
-
Machine set-up
regulations
The power source is tested to "Degree of protection IP23", meaning:
-
-
The welding machine can be set up and operated outdoors in accordance with IP23.
However, the built-in electrical components must be protected against direct wetting.
The venting duct is a very important safety feature. When choosing the machine locati-
on, make sure that it is possible for the cooling air to enter and exit unhindered through
the louvers on the front and back of the machine. Any metallic dust from e.g. grinding-
work must not be allowed to get sucked into the machine.

Mains connection

The equipment is designed to run on the mains voltage given on the respective rating
plates.
Fig.5
The power source can be run as standard on a mains voltage of 230 V~ (+/- 15%).
Thanks to its +/-15% tolerance range, it can also be run on the 220 V~ or 240 V~ mains.
Warning! Operating the equipment incorrectly can cause serious injury or
damage.Do not use the functions decribed here until you have read and com-
pletely understood all of the following documents:
- these Operating Instructions
- all „Operating Instructions" for the system components, especially the
„Safety rules"
the observance of all instructions in the operating manual
the carrying out of all prescribed inspection and maintenance work
Warning! A machine that topples over or falls from its stand can easily kill
someone. Place equipment on an even, firm floor in such a way that it stands in
a stable way.
Protection against penetration by solid foreign bodies with diameters larger than
12,5 mm (.49 in.)
Protection against spraywater up to an angle of 60° to the upright
195 V~
Tolerance ranges of the mains voltage
Note! If the power source is run on the wrong mains voltage, all warranty rights
will be forfeited!
230 V~
-15%
4
265 V~
+15%