Installing And Commissioning The Power Source; Safety; Installing The Power Source - Fronius TransSynergic 4000 Plasma Operating Instructions Manual

Installing and commissioning the power source

Safety

Installing the
power source
WARNING! If the power source is connected to the mains electricity supply
during installation, there is a high risk of very serious injury and damage. Read
the safety rules before starting the power source for the first time. Preparation
steps must not be carried out unless:
- the mains switch is in the „O" position,
- the mains cable is unplugged from the mains.
L 1
L 2
L 3
5
1. Connect the central earth from the
plasma system to the earth connec-
tion on the interface
2. Configure the mating connector on
the mains cable as illustrated