Chapter 5
Setup and Configuration
•
Section 5.2.3.3, "Deleting an SNMP Group"
Section 5.2.3.1
Viewing a List of SNMP Groups
To view a list of SNMP groups configured on the device, navigate to Administration » Configure SNMP »
Configure SNMP Access . The SNMP Access table appears.
Figure 70: SNMP Access Table
If SNMP groups have not been configured, add groups as needed. For more information, refer to
"Adding an SNMP Group"
Section 5.2.3.2
Adding an SNMP Group
To add an SNMP group, do the following:
1.
Navigate to Administration » Configure SNMP » Configure SNMP Access . The SNMP Access table appears.
1
Figure 71: SNMP Access Table
1. InsertRecord
2.
Click InsertRecord. The SNMP Access form appears.
122
.
RUGGEDCOM ROS
User Guide
Section 5.2.3.2,
Viewing a List of SNMP Groups