Displaying And Maintaining Rip; Rip Configuration Examples; Configuring Rip Version - HP 830 Series Configuration Manual

Step
3. Specify the interval for
sending RIP packets and the
maximum number of RIP
packets that can be sent at
each interval.

Displaying and maintaining RIP

Task
Display RIP current status and
configuration information.
Display all active routes in RIP
database.
Display RIP interface information.
Display routing information about
a specified RIP process.
Reset a RIP process.
Clear the statistics of a RIP process.

RIP configuration examples

Configuring RIP version

Network requirements
As shown in
Figure 55 Network diagram
Configuration procedure
1. Configure IP address for interfaces. (Details not shown.)
Figure 55, enable RIPv2 on all interfaces on Switch A and Switch B.
Command
output-delay time count count
Command
display rip [ process-id ] [ | { begin
| exclude | include }
regular-expression ]
display rip process-id database [ |
{ begin | exclude | include }
regular-expression ]
display rip process-id interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
display rip process-id route
[ ip-address { mask | mask-length }
| peer ip-address | statistics ] [ |
{ begin | exclude | include }
regular-expression ]
reset rip process-id process
reset rip process-id statistics
143
Remarks
Optional.
By default, an interface sends up to
three RIP packets every 20
milliseconds.
Remarks
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Available in user view.
Available in user view.