Table of Contents
Advertisement
Install the access panel
13.
Install the chassis into the rack
14.
Install the storage controller and FBWC module options in the node
15.
and FBWC module
Install all nodes, drives and power supplies
16.
If removed, install the security bezel
17.
If removed, install the RCM module
18.
Connect all peripheral cables to the nodes and chassis.
19.
Power up the nodes (on page 32).
20.
Installing the storage controller and FBWC module options
IMPORTANT: If planning to install a Smart Storage Battery, install it in the chassis before
installing the storage controller and FBWC module in the node
Storage
To install the component:
Power down the node (on page 32).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 32).
3.
Place the node on a flat, level surface.
4.
Remove the PCI riser cage
5.
Identify the PCIe slot compatible with the new option, and then remove the PCI blank opposite that
6.
slot.
Remove the bayonet board assembly and bayonet board bracket
7.
assembly" on page 43).
If you intend to use an FBWC module, install the module on the storage controller. Depending on the
8.
controller model, the cable connector on the cache module might be facing up or down when the
module is installed on the controller board.
("Install the chassis access
("Installing the chassis into the
options" on page 99).
("Security bezel
("RCM
Battery" on page 97).
("Remove the PCI riser cage
panel" on page 37).
rack" on page 58).
("Chassis component
installation" on page 60).
option" on page 67).
module" on page 70).
assembly" on page 48).
("Remove the bayonet board
("Installing the storage controller
("Installing the HPE Smart
Hardware options installation 99
Advertisement
Table of Contents
