Installing The Fan Option - HPE Apollo 2000 User Manual

Configuration
Non-redundant
Redundant
•
In a redundant fan mode:
If one fan fails, the system continues to operate without redundancy. This condition is indicated
o
by a flashing amber Health LED.
If two fans fail, the system shuts down.
o
•
The minimum fan requirement for this server to power on is four fans (fans 1, 2, 3, and 4).

Installing the fan option

For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
To install the component:
Power down all nodes
1.
Disconnect all peripheral cables from the nodes and chassis.
2.
Remove the node from the chassis (on page 32).
3.
If installed, remove the security bezel (on page 35).
4.
Remove all drives
5.
If installed, remove the RCM module (on page 34).
6.
Remove all power supplies
7.
Remove the chassis from the rack (on page 38).
8.
Remove the access panel
9.
Install the redundant fans in the left and right fan cages.
10.
Fan Fan
bay 1 bay 2
Fan Fan
Fan Fan
("Power down the node" on page 32).
("Removing the drive" on page 35).
("Remove the power
("Remove the chassis access
Fan bay Fan bay Fan
3 4 bay 5
Fan Fan Empty
Fan Fan Fan
supply" on page 34).
panel" on page 36).
Fan Fan
bay 6 bay 7
Empty Empty
Fan Fan
Hardware options installation 75
Fan bay
8
Empty
Fan