Align the air baffle over the DIMM slot latches and lower the air baffle.
a.
If a second processor and heatsink are installed, press down on the rear of the air baffle until it
b.
snaps into place on the heatsink.
Install any removed PCI riser cage assemblies
2.
Install the node into the chassis
3.
Connect all peripheral cables to the node.
4.
Power up the node
5.
Remove the bayonet board assembly
Power down the node (on page 32).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 32).
3.
Place the node on a flat, level surface.
4.
("Installing a node into the
("Power up the
nodes" on page 32).
("PCI riser cage assembly
chassis" on page 60).
options" on page 84).
Operations 43