Table of Contents
Advertisement
SFF SmartDrive
o
Low-profile LFF hot-plug drive
o
Remove the chassis access panel
Power down all nodes
1.
Disconnect all peripheral cables from the nodes and chassis.
2.
Remove all nodes from the chassis
3.
If installed, remove the security bezel (on page 35).
4.
Remove all drives
5.
If installed, remove the RCM module (on page 34).
6.
Remove all power supplies
7.
Remove the chassis from the rack (on page 38).
8.
Unlock the access panel latch using the T-15 Torx screwdriver and release the access panel latch.
9.
Slide the access panel back about 1.5 cm (0.5 in).
10.
("Power down the
node" on page 32).
("Remove the node from the
("Removing the
drive" on page 35).
("Remove the power
chassis" on page 32).
supply" on page 34).
Operations 36
Advertisement
Table of Contents
