Table of Contents
Advertisement
Install the FlexibleLOM 2U node riser cage assembly and secure it with five T-10 screws.
b.
CAUTION: To prevent improper cooling and thermal damage, do not operate the node unless
all PCI riser cages or rear I/O blanks are installed, and do not operate the node unless all PCI
slots have either an expansion slot cover or an expansion board installed.
IMPORTANT: If the PCIe riser cage assembly is not seated properly, then the server does
not power up.
Install the node into the chassis
9.
Connect all peripheral cables to the nodes.
10.
Power up the node
11.
Three-slot riser cage assembly options
NOTE: A second processor is required to install a three-slot riser cage assembly.
NOTE: Three-slot riser cage assemblies feature different riser boards. For more information
on the riser board slot specifications, see "PCIe riser board slot definitions (on page 26)."
To install the component:
Power down the node (on page 32).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 32).
3.
Place the node on a flat, level surface.
4.
Remove the 2U rear I/O blank
5.
("Installing a node into the
("Power up the
nodes" on page 32).
("Remove the rear I/O
chassis" on page 60).
blank" on page 39).
Hardware options installation 93
Advertisement
Table of Contents
