Table of Contents
Advertisement
Install the node into the chassis
12.
Connect all peripheral cables to the nodes.
13.
Power up the node
14.
Single-slot 2U node PCI riser cage assembly option
To install the component:
Power down the node (on page 32).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 32).
3.
Place the node on a flat, level surface.
4.
Remove the 2U rear I/O blank
5.
If you are installing an expansion board, remove the PCI blank.
6.
Install any optional expansion boards.
7.
Connect all necessary internal cabling to the expansion board. For more information on these
8.
cabling requirements, see the documentation that ships with the option.
Do the following:
9.
("Installing a node into the
("Power up the
nodes" on page 32).
("Remove the rear I/O
chassis" on page 60).
blank" on page 39).
Hardware options installation 88
Advertisement
Table of Contents
