Table of Contents
Advertisement
1U left rear I/O blank
o
2U rear I/O blank
o
Install the node into the chassis
2.
Connect all peripheral cable to the node.
3.
Power up the node
4.
Remove the air baffle
Power down the node (on page 32).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 32).
3.
Place the node on a flat, level surface.
4.
If installed in a 2U node, remove the FlexibleLOM 2U node riser cage assembly
5.
node riser cage
("Installing a node into the
("Power up the
nodes" on page 32).
assembly" on page 52).
chassis" on page 60).
("FlexibleLOM 2U
Operations 41
Advertisement
Table of Contents
