Table of Contents
Advertisement
Install the single-slot 2U node PCI riser cage assembly and secure it with two T-10 screws.
a.
Install the FlexibleLOM 2U node riser cage assembly and secure it with five T-10 screws
b.
("FlexibleLOM 2U node riser cage assembly
CAUTION: To prevent improper cooling and thermal damage, do not operate the node unless
all PCI riser cages or rear I/O blanks are installed, and do not operate the node unless all PCI
slots have either an expansion slot cover or an expansion board installed.
IMPORTANT: If the PCIe riser cage assembly is not seated properly, then the server does
not power up.
Install the node into the chassis
10.
Connect all peripheral cables to the nodes.
11.
Power up the node
12.
FlexibleLOM 1U node riser cage assembly option
To install the component:
Power down the node (on page 32).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 32).
3.
Place the node on a flat, level surface.
4.
If installed, remove the single-slot left PCI riser cage assembly
5.
assembly" on page 48).
Remove the rear I/O blanks
6.
("Installing a node into the
("Power up the
nodes" on page 32).
("Remove the rear I/O
option" on page 91).
chassis" on page 60).
("Single-slot left PCI riser cage
blank" on page 39).
Hardware options installation 89
Advertisement
Table of Contents
