Table of Contents
Advertisement
To install the component:
Power down the node (on page 32).
1.
Disconnect all peripheral cables from the node.
2.
Remove the node from the chassis (on page 32).
3.
Place the node on a flat, level surface.
4.
Remove the FlexibleLOM 2U node riser cage assembly
5.
assembly" on page 52).
Set the accelerator power setting switch to the correct settings based on the power consumption of
6.
the processor
("Accelerator power setting
For more information, see the documentation that ships with the accelerator option.
If installing a half-height accelerator, remove the middle PCI blank only.
7.
If installing a full-height accelerator, remove the middle and the top PCI blanks.
8.
Connect the single accelerator power cable to the connector on the riser board.
9.
("FlexibleLOM 2U node riser cage
switch" on page 104).
Hardware options installation 106
Advertisement
Table of Contents
